JINTAI Sleeve Bearing Manufacturer Contains instructions to monitor the working conditions, make up or replace the lubricant, check the time to open. As the maintenance of the work, there are all the bias arm bearing the rotation of the sound, oscillation, temperature, the status of the lubricant and so on.
     1. The oil bath of the bearing is lubricated
Oil bath lubrication is imported in the ordinary lubrication method, suitable for low, medium speed bearing lubrication. FAG bearings will be partially immersed in the tank, the lubricating oil from the rotating bearing parts brought back, and then flow back to the oil tank should be slightly lower than the center of the minimum tumbling body.
     2. Lubricant lubrication of the bearing
Drip lubrication suitable for the need for quantitative supply of lubricating oil bearing parts, a single drop of oil per 3-8 seconds a drop is appropriate, too much oil will lead to all the bias arm bearing temperature increases.
     3. The circulating oil of the bearing is lubricated
With oil pump will be filtered oil to the bearing parts, through the FAG bearings after the oil and then filter the use of cooling. As the circulating oil can take away the necessary heat, so that the bearing cooling, so the law for high speed bearing parts.